
DATA SHEET BX 20 AIT

TYPE OF PRODUCT
	Two components solvent based adhesive for print lamination , ready to use after mixing its crosslinker BTX-C.
ASPECT
	Wet : liquid, transparent to yellow Dry : transparent and gloss
OPERATION
	Ready to use adhesive supplied at 20 seconds CF4 , to be adjusted depending on the final requirement or formulation. Suggested solvent are : isopropyl acetate, toluen, ethyl acetate. Standard adhesive formulation is the blend of 10 to 15% of crosslinker LPP ref BTX-C
PROCESSING
	Any machine using doctor blade, or reverse rolls, or equivalent. Drying with air jet, or hot air tunnel,or IR, or drumm etc... The use of this product has to meet requirements of local rules or regulations relative to v.o.c. emission. Cleaning : with solvent such as ethyl acetate.
CHARACTERISTICS
	Convenient for most of substrates commonly used for lamination : paper, polyamid, pet, pe, polypropylen (plain, acrylic coated, metallised, pvdc..) .. with wetting tension over 38 dynes/cm². This product offers a good compromise between cohesion and adhesion , and provide good result on porous substrate .
RESTRICTION
	Avoid glueing on materials with low wetting tension as wax, lacqure, silicon...
STORAGE
	Closed drumm : 6 months , no ageing of two components adhesive. Pot life : depending on formulation and room temperature, 4 hours with crosslinker BTX-C ; add solvent to make up for evaporation and keep the right viscosity .